Looks like there is no 2 bar PID that I can install in my scanner config to tune my 2 bar OS. I saw a mention in a thread here that its not available for a 98? If so, then what do I do to tune under boost? I'm back to using PE table only then which is the same as my old 1 bar OS. Hoping I didn't go through the trouble of upgrading only to not be able to use it..
Everything is running nicely with the 2 bar installed other than that.
Procharged 98 Z28
2006 Trailblazer SS
Correct as stated in the help file 98's don't need a special pid.
It doesn't have to be perfect, it just needs to be done in two weeks...
A wise man once said "google it"
ok but how do I get the table to read past past 100 kpa or whatever its at so i can see whats going on under boost?
Procharged 98 Z28
2006 Trailblazer SS
Reply With Quote