Tune and Scan After 3" DP Install

[Jae30001]

Thoughts?

[MMGT1]

Looking real rich there. Take 10% from your MAF scale and get another log. Should get you a little closer so you can fine tune it from there

[Jae30001]

MAF vs Output Freq? Multiply by .90?

[MMGT1]

yes. That should get you a lot closer, then you need to use LTFT+STFT and paste special, multiply by % until you are within a couple of %. Once you are within, lets say 3%, multiply by %half until you get as close to 0 as possible. I am around 0.8 across the table now, locking in at 0% in PE every time