Well I had a mishap when i swapped out my clutch, pinched the section of the harness that reads ECT, rear 02, and the speed sensor. Since then ive fixed the wiring and replaced the sensors but still had the same problem. I put my ECM in another balt and the problems showed on that car. So I determined it fried or shorted somthing in there.
Question is if I replace the ECM what all is required to get it working correctly? Crank relearn? seed relearn? Clutch relearn? And if i change the vin via HPtuners will it allow me to tune it with out having to recredit it?