OKAY, new to the whole tuning world but have a solid background in engineering so most of this makes sense after a while...but I am little impatient
So, I have set up a basic SD 2.0 BAR tune open loop for my 1969 Nova with a 4.8 L T70 T56 combo.
I am running a 2001 Camaro ECM and a rewired harness.
Last year, the car was a LS1 car, ran great, put 5K+ miles on it.
Now, I wanted more power so I built this very nice turbo set-up…top notch.
Long story short, I had the car running the other day with the stock injectors in the car from when it was an LS1.
I am planning to start running some big power on E85 by the end of summer (hopefully) so I bought brand new 160 # hi imp injectors from FIC.
Seeing as I seemed to have the car stable and workout any major issues, I felt it was time to install the 160’s.
Dropped them in, all seemed good….
I just tried to fire up the car, see what it would do and it only tries to pop a little….tickle the throttle and it will sputter….
Well, I figure this is the time where I jump back on the learning curve…
So, I have a spread sheet with three tabs worth of data and have no idea where to put the info except for the voltage offset (which I have no idea what that relates to!).
This is where I need help; where do I use the other two tabs of spread sheet data?
Also, how do I tune the idle?
I have gone ahead and ordered the Greg Bandish CD but that is not due in until next week Tuesday, PLEASE HELP!
Thank you
Adam