Hi Fellas,
I need a little help, i was tuning a car a few nites ago with the sensor in my dyno probe, the sensor/harness connector fell into the exhuast gas stream and completely melted...........
Could someone with an AFX with the NTK sensor grab theirs and tell me what colour wire on the sensor plug joins to the wire in the harness plug?
I just need to get this up and running until my replacment harness and sensor arrive.......
Thanks Heaps!!!
Steve
02 BA XR6T, Crow Race Valve springs, centre muffler removed, 60lb siemens and stage 2 PW cooler+UB intake, 307RWKW at 12psi. SOLD
99 Nissan Patrol, l77 ls2 + 6L80 swap SOLD
2013 Gen-F HSV Clubsport R8 - Work in progress
I'll have mine out today while I move it further downstream. I will check and post a pic in a couple hours if you can wait.
Photo taken from the harness side. Lock is on the bottom.
TBLTZ that's awesome dude, any chance you could get the other side of the connector as well, mine is totally melted.......
02 BA XR6T, Crow Race Valve springs, centre muffler removed, 60lb siemens and stage 2 PW cooler+UB intake, 307RWKW at 12psi. SOLD
99 Nissan Patrol, l77 ls2 + 6L80 swap SOLD
2013 Gen-F HSV Clubsport R8 - Work in progress
Top of pic is harness, bottom is sensor.
DSX Tuning - Authorized HP Tuners Dealer
http://www.dsxtuning.com
http://www.facebook.com/dsx.tuning
Just say no to bull s***.
IF YOU WANT HELP, POST A FILE!
I thought i had replied to this but it must not have worked......
Thanks heaps guys!!!!!
Steve cooper
02 BA XR6T, Crow Race Valve springs, centre muffler removed, 60lb siemens and stage 2 PW cooler+UB intake, 307RWKW at 12psi. SOLD
99 Nissan Patrol, l77 ls2 + 6L80 swap SOLD
2013 Gen-F HSV Clubsport R8 - Work in progress
Reply With Quote
