Fried my ECM YEAH!!!

[jkade72]

--------------------------------------------------------------------------------

Well I pulled a good one , I am new to tuning and fried my ecm. Swapped a 6.0 4l80e into my CCSB had hptuners support do the segment swap for the tranny. I decided I would copy and paste the remaining files from the donor file. read the warning about the desired throttle area soo I decided not to copy this I went back and changed the area back to stock or so I thought...hopped in the truck rewrite calibration and truck goes apeshit, reduced engine power ect pegs and now it wont start or even click for that matter. I guess I will visit the junk yard for a new computer, should I get one out of a 2005 half ton or can I get one out of a 2005 2500 so I wont have to do the segment swap again. I have a lot to learn about tuning a little more to it than turning wrenches

[spike]

what vehicle is this on? I was had that issue once but it was only with a beta version. Once i got another one it was fine or if i used 2.22 it was ok.

[jkade72]

2005 1/2 ton chevrolet truck.

[CalEditor@pcmcalibrators]

We fix bricked PCM's

[jkade72]

Here is the tune that fried my ecmAttachment 28489

[ls88foxbody]

Really? Once I get my bench tune stuff Next week I will see if mine will open or not. I think Maybe Injector drive is junk.

[Bill@HPTuners]

Likely the desired pedal area table you changed.

[1969x11]

Likely the desired pedal area table you changed.

Yep that was it. I wont make that mistake again.