yes yes i am a newbie! i have my scanner working correctly but the only problem i am having is my boost is not reading on my scanner. just says
-14.50. just wondering if someone would be able to point me in the right direction for that! btw its a 2009 slowbalt t/c.
I believe the answer to this is in the tune/ config repository.
09 Imperial blue ss/tc, sunroof, g85.
Mods: Gms1, K&N sri, Injen cp, cia 3"catted dp, 3" Cia catback/ res delete, zzp ic, ottp stage 1 rotated mount, forge bpv, twm sts/ bushings, eibach sportlines, hawk hps pads, 235/40/18 BFG Gforce Ta kdw2's.
Boost: Sensor - Manifold Absolute Pressure
Function: [PID.11.PSI]-14.5
09 Imperial blue ss/tc, sunroof, g85.
Mods: Gms1, K&N sri, Injen cp, cia 3"catted dp, 3" Cia catback/ res delete, zzp ic, ottp stage 1 rotated mount, forge bpv, twm sts/ bushings, eibach sportlines, hawk hps pads, 235/40/18 BFG Gforce Ta kdw2's.
i have already tried that a couple times. ive also tried a couple different things but im not doing something right. and everytime i try it it either shows nothing or it stays at -14.50 the whole time. but ill keep trying some stuff and see what happens thanks though
You have to be logging the map pid first, then you add a custom pid based on it.
I am already logging map, and made a custom PID with the map, set it to psi, and then went in the help section to where it converts kpa (sorry if I'm incorrect) to psi. It pops up when I am logging, but stays at -14.50. So I'm just wondering what I am doing incorrectly. I have been in the config resp, but nothing has worked. I'll double check again everything in the morning just to be sure I don't have something messed up
Here is how I have my custom PID setup:
Reply With Quote