Contacted Support and Bill asked that I post this. Please post if you've found the samething, he's going to ask Chris to chime in on this thread. Thanks.
The Fuel Mass mode runs strange and I tried to adjust the ramp tables a bit to help but it made no change. It will run double fuel pressure everywhere tho and then hold at the max when it reaches it.
The real issue tho is when in Normal (pressure) mode and I adjust the Pressure Table to suit my needs, I get the Max % just fine but I can’t control it properly between 3-5k. I have it set to be 11.7MPa (1700psi) and the car immediately goes to 2-2100psi and then ramps to 2200 and holds. No matter how much I reduce those values the car will still run the same fuel pressure.
And we need to be able to log Fuel Rail Pressure please! When messing with this stuff, this is a necessity IMHO. We can log the commanded rail pressure but not the actual. (which is how I caught it not working right, the commanded is showing different values then my actual tables). The commanded shows it commanding 15MPa in spots where NO table is set to that. So Im confused why this is not working properly.
Thanks!