Results 1 to 3 of 3

Thread: AEM 30-2310 issue

  1. #1
    Tuner in Training
    Join Date
    Jun 2007
    Posts
    38

    AEM 30-2310 issue

    I'm having an issue with an aem 30-2310 wideband in an 09 CTSV. The wideband reads fine in the datalogger at idle and at cruise, but on a full throttle pull it loses signal at times. For example it will read perfectly if you just make a one gear pull on the street, but on a full 1/4 mile pass it will cut out and just go to full lean after a couple of gears and stay there. The car isn't really lean though.

    Has anyone else had this issue with logging a wideband? I'm thinking it may just need a better ground or something (currently grounded to the chassis), but I don't have the car here right now.

  2. #2
    Tuner
    Join Date
    Jan 2013
    Location
    Delaware
    Posts
    67
    my friend, you might make for certain your not going too lean and pump some more fuel in to make sure. also checking for loose connections would be wise aswell

  3. #3
    Senior Tuner SultanHassanMasTuning's Avatar
    Join Date
    Nov 2009
    Location
    All Around
    Posts
    3,149
    where are you getting your voltage from?

    these gauges (sensors) operate at a max of 5v