1x Signal, 1 Bolt - Camshaft GEAR

[Christian GM]

hi guys,

who knows the correct GM p/n of this item?
here there are all the specs off all the gears, but less the one I need:
http://www.ls2.com/forums/showthread.php?p=9948162

thank you!!!

[c.u]

well the p/n 12591689 come`s back as timeing set for the express,savana, 4.8l,5.3l.6.0l .v8`s.

[Christian GM]

this p/n is for the 4x signal...
I need the 1x signal.

thank you.

[DSteck]

I don't think there is a 1x single bolt cam gear. You can use a 4x cam gear with a LPE converter box though.

[Christian GM]

I don't think there is a 1x single bolt cam gear. You can use a 4x cam gear with a LPE converter box though.

wow, should be easiest than replace again the gear.
do you have the p/n?

thank you!

[DSteck]

I'm not sure what the part number is for the single bolt 4x gear, but it is from an LS3. The Lingenfelter converter box is $254.95.

http://www.lingenfelter.com/mm5/merc...gory_Code=C163

[Christian GM]

ok, the gear I need is not yet produced.
I will change another time the camshaft ...

bye

[jakebdb56]

What are you wanting a 1x signal for? There's no stock VVT OS that supports a signal from that 1x (same signal as what comes off the back of a GenIII camshaft ) cam gear. If you need that readout, just modify the valley cover to where you can put a gen3 cam sensor on the block behind the intake and catch the 1x off the camshaft, that is if the single bolt core you have has the two half rings on the back of the cam.

[jakebdb56]

Which that cam core doesn't have that pickup ground into it. suuuucks