I have been working on this Lambda err Maf & Ve config I am pretty
close i think, when i connect i get unsupported parameter on Lambda_err
and Commanded Lambda then it does not show in user defined but its still
there if i click on undefined it shows up and just erase one letter and put it
back and it seems to work and the histogram shows ok until i click between windows and it stops working. I made it today with a bench harness and all was good it saved right and seemed to work when i connected, but not on the car never got to the point of starting it. It seems kinda buggy but this
software is new to me. I attached the the config, did I forget to put something in the table display?