Configurations and Data Logging

[JWJ438]

I’m new to the VCM Scanner and Suite program and have a few questions. I purchased the MPVI Pro and have scanned my 1998 GMC 7.4L truck as well as my 2009 Cobalt SS 2.0L TC. The issues I’m running into are

1) Following the help instructions I can not data log with the interface alone. I get an error as soon as I press record.
2) The data captured (from the GMC) doesn’t seem to stay the histograms and only seem to be supported
3) On the Cobalt there seems to be a cal liberation issue I never see a TPS below 15% or above 85%

I have tried setting up different PID’s and configs but have seen no change. Any words of wisdom for a beginner as to extracting data and setting up configs?

[JWJ438]

Sorry

#2) Only 3 of the 12 avalible histograms seem to be supported and it seems the data and or sensors are there to support a few more?

[Bill@HPTuners]

1. send support a vcm suite infolog while connected to your interface, I think I know what the issue is
2. Post a scanner log & the config you are running
3. Normal.

[Google]

#3 you can log more then one TPS one of which sould read 0-100%

[JWJ438]

ok figued out #2 "inexperienced Operator" The info was there
#3 Was using the 1998 GMC config on the Cobalt also probly why no histograms logged

[JWJ438]

#1 answered ... waiting for an update from support to make work.