Service Engine Soon / Hard Start Please Read

[TXZ0603]

Pulled the codes on both the DIC and through my HPTuners. The only codes showing are the p0102 and p0103. My car is in SD so they should be there. I have them set to 2-no mil light. Been like this for a while except now the ses message is on each time I start the car. Any Ideas as to why I now have that message????

Also, I have noticed that my car is getting harder and harder to get started aft I flash a tune. This has been going on for at least 6 months now. For the last month or so, If I just read the tune for my car, no flashing involved, it is hard to start. Takes about 15-20 tries to get running.

Thanks

Jerry

[Russ K]

Uncheck the SES enable boxes for the Maf codes. Your VE table looks very odd.

Russ Kemp

[TXZ0603]

Thanks Russ. It looks odd cause I am spraying a MESS load of meth on the top end

[TXZ0603]

Fixed it. Unchecked the 102 and 103 ses enable codes. Also set the MAF fail to 12.5Hz. Worked like a charm. Thanks Russ

[gokussx4]

May be a bit late for this but don't you need the ses enabled to get into SD mode? The mil light setting should be for just that.

I am having a similar issue, don't want the light to come on for SD Tuning. #2 mil light off set on p0103 and maf hi fail set to 0. Service light still comes on.

[Frost]

No, you un-check the SES enabled, set the error to 0- Mil on first, set MAF fail freq to 0, and put 12.5g into the first cell of the MAF table. I usually zero the rest of the table.