Results 1 to 4 of 4

Thread: MAP won't change

  1. 08-02-2010 #1
    kid
    kid is offline
    Tuner in Training
    Join Date
    Jul 2010
    Location
    Milford, CT
    Posts
    29

    MAP won't change

    In my latest log, my MAP stayed at 92.0 the entire run. Is this a sensor issue, or something in cfg?
    Reply With Quote Reply With Quote
  2. 08-02-2010 #2
    umrjmac
    umrjmac is offline
    Advanced Tuner umrjmac's Avatar
    Join Date
    May 2010
    Location
    Lenexa, KS
    Posts
    301
    For my car, anyway, MAP is Manifold Absolute Pressure (SAE), not Manifold Air Pressure. And it should log in kPa or psi, not volts
    Kenne Bell Supercharged 2003 Corvette Z06
    Reply With Quote Reply With Quote
  3. 08-02-2010 #3
    Frost
    Frost is offline
    Senior Tuner Frost's Avatar
    Join Date
    Jan 2006
    Location
    Richmond VA
    Posts
    1,950
    definitely a sensor/wiring problem there. I'd lean more towards sensor based on the data available but I'd checkout the wiring before I spent the coin.
    Steve Williams
    TunedbyFrost.com
    Reply With Quote Reply With Quote
  4. 08-02-2010 #4
    kid
    kid is offline
    Tuner in Training
    Join Date
    Jul 2010
    Location
    Milford, CT
    Posts
    29
    umrj-I logged both air pressure and absolute pressure because I wasn't sure which to use. It's the Kpa that isn't changing.

    Frost- I have to run a new vacuum line for my heater controls, so while i'm in there I check the wires. How do the rest of my numbers look? The car is running smooth and strong!
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »