How do I attach logs?

[darrellk]

As stated, how do I attach logs so I can get some help on why my 2 bar is logging 7-8psi at idle. Also, I just want to know how to post up logs for future reference.

[darrellk]

I used the help menu and went to table display and deleted the map sae pid, and inserted the map 2 bar and then went in to the charts and changed the properties to map 2 bar pid and at idle it is logging 7-8psi. Is there a way to calibrate it or something that I am missing out on?

[Bill@HPTuners]

7-8 psi ie 45-50kpa which is perfectly normal for idle.

[darrellk]

Ok, so when I get into boost will it read 14 psi or would I have to add 8psi to that for the idle?

[darrellk]

So that would make it read 22psi for 14psi of boost correct?

[darrellk]

Now, how do I attach logs to the HP TUNERS?

[Bill@HPTuners]

So that would make it read 22psi for 14psi of boost correct?

The psi reading does not account for atmospheric pressure so if you are reading 30psi in the scanner you would subtract atmospheric pressure from that to get positive boost pressure ie 30-14.5=15.5psi of positive boost pressure.

[Bill@HPTuners]

Now, how do I attach logs to the HP TUNERS?

to the hptuners? Not sure what that means but if you are trying to attach logs to your post just use the manage attachments feature.

[darrellk]

Logging two bar idle.

[darrellk]

Third gear pull

[darrellk]

Logging two bar at idle was when I switched it in the table display. First third gear pull was when I was logging 1 bar and switched it after the fact, thats why its not displaying.

[darrellk]

Is there a conversion formula I should use to get it reading correctly?

[Bill@HPTuners]

Is there a conversion formula I should use to get it reading correctly?

Get what reading correctly? I looked at the log & its reading just fine.