I have a 2010 Silverado. There is not a explanation in the help section. In the PART THROTTLE SHIFT there is 4 tables. NORMAL, PATTERN A, PATTERN B and HOT. Could someone help me with what the 4 tables are used for? I like the shift pattern of PATTERN A, can I copy and paste it to NORMAL? And is NORMAL table what the PCM looks at under normal conditions? Thank you for any help you can send my way.
The normal tables are used while in drive. If you have a tow haul button it will use Pattern A. The hot tables are used when the trans goes into a over temp condition, the saftey shifts are used if the trans goes into a limp home mode. TAP up/TAP Down are for manual mode.
Can you post up your tune file?
Ian
2008 Corvette A6 - Comp Cams 231/239 617/624 109 ICL 113 LSA, Patariot Extreme Dual Springs .660", Milled .30" Stock LS3 Heads, Mahle -4cc pistons, FTI 3600 Converter, 1 7/8 kooks cat-less 3 inch X-Pipe, air raid intake, ported TB, SLP Loudmouth I. 512hp/464tq
2011 Ford Taurus SHO - stock with just a Tune
Here is my factory map, thank you for the help.
Reply With Quote