VE tuning for 2006 grand prix gxp ls4

[mspeterso]

I tuning the VE table for my ls4
by disabling the MAF
copying over the high octane table to low octane table.
put pe enable mode at 100% tps.


The problem i had is that duirng this mode. shifting is really rough.
normally shifting is fine.

Is there any settings to look at ( torque settings from shifting. this may of been modfied from stock tune.

The trans temperature also runs up to high when maf disabled
i am afraid i am hurting tranny - i just got a fresh rebuilt on transmission
with shift kit and upgraded torque converter

[crh1023]

Mine shifts super hard too, I have a transgo shiftkit, I just assumed that was why??

[MikeOD]

Post the file. On some setups there's a max line pressure when the MAF is failed check mark that you can turn off.

[crh1023]

It worked, thanks!