You provided a link in your signature on how to tune your MAF.
You indicate to flash the car back to 'normal' then:
1) Create OLMaf (bin)
2) Disable Closed Loop.
3) Dynamic Air - Hi/Lo RPM Thresh = 0
4) Create PID table for MAF only tuning.
5) Setup a MAF AFR Error Histogram
(With a note that yours indicates Decel Fuel Cut off is filtered out.)
I guess where I get lost is step 5 and 6.
Sure I can setup a table that looks exactly like your screen shot, and a Histogram that's the same, but your screen shot Histogram shows a VE table not a MAF table.
I still don't understand how to create your own Histograms or reference filters and how you even know what sensor [SENS.121] is.
Also; following these steps, wouldn't the STFT and LTFT throw everything off? or do they not come into play because of CL is disabled?