pulled up wrong vehicle

[stanger383]

I hooked up my laptop to use the scanner on my new truck and it pulled up the wrong model. I have a 2009 vortec max silverado with 6.2 403 hp and 6 speed auto and it said I had a 2007 HHR with inline 4. Ive never had it hooked to an HHR. i also noticed that the temp reading was incorrect. the dash said 210 which im sure was correct and the scanner said 190. I wouldnt know what other readings were in error because most others are not reported via the factory dash. Has anyone seen anything like this?

[Bill@HPTuners]

Sounds like you need to contact support with a vcm suite infolog while connected to the vehicle in question.

[markislive]

I hooked up my laptop to use the scanner on my new truck and it pulled up the wrong model. I have a 2009 vortec max silverado with 6.2 403 hp and 6 speed auto and it said I had a 2007 HHR with inline 4. Ive never had it hooked to an HHR. i also noticed that the temp reading was incorrect. the dash said 210 which im sure was correct and the scanner said 190. I wouldnt know what other readings were in error because most others are not reported via the factory dash. Has anyone seen anything like this?

Sounds like they shorted you 4 cylinders...LOL!

Vortec Max is the 6.0L, 09' 6.2L is a L9H (flex-fuel version of L92)

Once you get everything workin here's a nice VCM scanner config file for our motor...BTW the temp gauge on my truck is not true either, trust what u see using VCM Scanner my dash gauge shows 210* even though I run @ 178* on the hwy with a 160* stat installed. My truck ran 190* on the hwy with the stock stat and up to 210* in stop n' go traffic. The needle will move if you overheat : )

[stanger383]

i guess your right its not called the vortec max. i traded my 07 vortec max in on this 09 6.2l . I wanted it in 2wd but could only get it in 4wd. what other things have you done to yours?