Does anyone know how to change the default output on a LM-2 to AFR? Everytime I connect the unit, I have to reprogram it to output AFR to HPT.
Does anyone know how to change the default output on a LM-2 to AFR? Everytime I connect the unit, I have to reprogram it to output AFR to HPT.
Do the settings reset or does the fuel type change to custom?
If so you may have a ground offset or a low voltage.
The settings for what to output reset everytime I power on the unit. I need to go into the LM Programmer and set it to output AFR and reprogram. Once i do this the LM and HPT look identical. Everytime I open the LM Programmer it is set to output Lambda.
I dont think it is a ground issue, as even playing with it just plugged into the laptop it does the same thing.
Last edited by omega_5; 03-16-2010 at 03:20 PM.
Tyler
cool, thanks