I can open the files i have licensed but when i try and do a write it asked me to license again. Never happened before, this is new. I can send in the info log while connected to vehicle, but will that help? It doens't ask me to license the file when i open it like it normally would on a different non license vehicle.
Just sent log file and known licensed VCM file to HPT support email address as well.
Last edited by u00bse1; 02-13-2010 at 06:29 PM.
when you show license info does that vehicle show up as licensed on your interface ?
theres a couple layers asking you if you are sure you want to license this file ( 3rd one is commit as I recall) I had a similar issue before and on the first screen if I would click on show license options then it would recognize the vehicle and say you allready have a license for this vehicle.
do be careful though and do not go in far enough to actually license it again -read carefully the questions it asks you
you will burn credits if you commit on the last screen
PB's 1/4 mi 12.21 117.75 trap ,1/8 mi. 7.779 93.99trap , 1.949 short time (FWD W body)
This is a vehicle I have written to for months prior to today. So i am not sure whats going on. When i open the log file and look at the VCM ID number it matches the calibration details in the file i am trying to load / write.
Last edited by u00bse1; 02-13-2010 at 06:28 PM.
I just had the same problem today. I am emailing support for an answer as I type.
2001 Camaro SS M6 #1172
Forged 347,PP Stage II 59cc,
244/248 .617/.622 107+4, 42lb inj.,
Ported Vic Jr./ 4150 Accufab
Spec 5,Full Suspension,
Moser 12 Bolt w/4.30's w/ a spool
Reply With Quote