Guys please help me out with this config!

[ls1greyhound]

I have my NGK wideband hooked up to my EIO and its reading the AFR correctly on the Main Table (The wideband is using the predefined PID for the NGK afx). I am logging Commanded AFR, and % afr error. The problem is that histograms #6 (wideband afr) and #7 (% afr error) are recording the wrong values.

I suspect this has something to do with SENS.120 reporting incorrectly, because when I tell histogram #6 to reference the pid for the NGK wideband, the table will record the correct values. But, this doesn’t help me with histogram #7 because the PID cannot be changed. I don’t know what I changed to affect these two histograms but they were working fine a few days ago and now they are not.

Would someone please take a look at this config file and data Log and help me figure out what is going wrong:



Thanks in advance,
Scott

[ls1greyhound]

Nevermind, Bill at Hptuners helped me fix this.

Thanks Bill!

[angrygoat]

what was the fix?

[Bill@HPTuners]

In his case it was a custom pid skewing his values