select Vehicles?

[viper04af]

is there a way to select the Vehicles if your HPT has been hooked up to a bunch?

the time i used it was hooked up to my truck now i need to adjust my scanner and my car is down so i can't hook it up to my car to get its parameters

also is there a way to transfer that to my desk top? (witch is what i use to tune most of the time becuase the screen is bigger)

[Bill@HPTuners]

You can modify the VCM Scanner.cfg file but the parameter list will likely be inaccurate until you actually connect to the vehicle.

[viper04af]

You can modify the VCM Scanner.cfg file but the parameter list will likely be inaccurate until you actually connect to the vehicle.

so there no way to get my dest top right with out getting it very close to the car?

[Bill@HPTuners]

Yup. It will be close but might not be exact until you actually poll the vehicle.

[viper04af]

Yup. It will be close but might not be exact until you actually poll the vehicle.

what about my lap that has already been connectec to the car?

EG was on car

moved to truck to scan codes

can't move back to car becuase its down.....

i see the the file for the car under the vehicels folder but i can't get it to use it

so if i change it like you say will i still need to connect it? or does it make a new file everytime you connect to the car