Does the AFX come read for the NTK or Bosch? Can you switch from one to the other or do you have to buy it ready for the NTK?
Does the AFX come read for the NTK or Bosch? Can you switch from one to the other or do you have to buy it ready for the NTK?
Sulski Performance Tuning
2000 WS6 M6 - LS6 (long block, refreshed top end), 10.8:1 CR, 90 mm ported FAST, Exo-Skel, 227/232 cam, QTP HVMC, EWP, GMMG, 9" w/4.11s
2018 Sierra SLT 5.3L A8 - Airaid intake tube, GM Borla catback, L86 Intake/Ported TB
I take it you can not just swap out to a better sensor? In a perfect world?
I believe you can just swap them. but i'm not 100% sure. maybe shoot them an email: [email protected]. i'm sure they would know.
Here's all the sensors sold separately:
http://www.bmotorsports.com/shop/ind.../cPath/129_141
ThanksOriginally Posted by boomer
Well, I have unlimited amount of copper sheet metal play with. The directions that were in the box says to just bend two sides parallel to the exhaust piping, to allow for air flow around sensor. I was thinking maybe closing in all four corners and leaving the top of sensor open. Bad idea?
Reply With Quote