I have a request for some extra PIDs for the 6L80 in the Scanner. I don't know if they are even available but if they are they would be nice to have.

1. Driver Demand Torque - Probably in the ECM not the 6L80 but apparently is referenced in a lot of tables.

2. Inertia Factor Profile Number - The number of the inertia factor profile that the trans is currently in (1-9). Would make it easier to work out the cells that are being referenced in quite a few TCM tables

3. % of shift completion. Again would make looking up the cell being referenced easier. I don't know if this is the same for Shift time transition Initial/Final (0-1) and Desired output Torque (0-1)