Results 1 to 2 of 2

Thread: My 6 wire LC1 setp. more info needed.

  1. #1

    My 6 wire LC1 setup.

    So my 7wire is being repaired. Temp using a buddies 6 wire, which there seems to be a bunch of lacking info one.

    Well here is my current config.


    The wideband works prefect. .025 off set.

    I have wired the LC1 2 ways. getting the power from a switched 12volt source and grounding to the chasis or getting the power and ground from the 02 sensor. Both seem to work the same.
    Last edited by beamar; 10-22-2008 at 09:04 PM.
    99 T/A. g5x4 cam. Now trying to figure out how to tune it...

  2. #2
    so did a little reading, have a feeling I have to set the gauge to use the yellow wire and program that output as a narrowband and not a wideband....

    will try it when i get home.
    99 T/A. g5x4 cam. Now trying to figure out how to tune it...