Using VCM Suite 2.2 fails on step:
6. Reading Entire VCM gets FAILED
VCM Read Failed at loc: 0 Error Timeout
any ideas?
Note:2008 model
Using VCM Suite 2.2 fails on step:
6. Reading Entire VCM gets FAILED
VCM Read Failed at loc: 0 Error Timeout
any ideas?
Note:2008 model
Last edited by SRPerformance; 10-16-2008 at 03:03 AM.
LS1 LS2 LS7 tuner, L98, LT1 & Haltec
3 steps you should try
1 make sure ya scanner if the program is open is set in the "disconnect" mode.
2 ignition is in the on position when doing a read or write
3 if the above is ruled out, disconnect the MPVI from the usb and the obd2 port - should be no power light on the box, then reconnect and retry.
And if all else fails contact support http://www.hptuners.com/help/index.h...mersupport.htm
There are some 08' E77 Alloytech pcm's we currently do not support which is probably the issue you are running into.
It doesn't have to be perfect, it just needs to be done in two weeks...
A wise man once said "google it"
We hope to have it soon please .
Thanks ,
Zi5
Last edited by Zi5; 10-02-2009 at 06:12 AM.
Any news about E77 PCM ?
Last edited by Zi5; 10-02-2009 at 06:13 AM.