Hi guys, need some help.
I had an issue last year about my LM-1 WB reading fine at normal cruise but when I went WOT it was on the rich side when compared to the dynos WB 02.
Here's the tread from last year:
http://www.hptuners.com/forum/showthread.php?t=13828
I went back and reset my LM-1 and tried it again and it did seem to help some but not 100% sure. I even used a brand new 02 sensor.
I haven't really tuned that many cars this year but the last one I did, same thing, I was reading around 13.0 and the dyno was around 12.5. Part throttle WB O2 readings were 14.7 with my LM-1 and the dynos WB 02. I used 2 different 02 sensors and after I calibrated them in free air (for the heater and O2) it didn't make a difference.
Why is this? I thought the LM-1 was plug and play with HP Tuners?
I see there is a write up for the LC-1 what about my LM-1? Is there an offset that needs to be done? How should I have my LM-1 Setup? Looking for something simple, set by step.
Thanks in advance...
Bill