histogram map values not populating properly

[BobDoLe]

i'm having a problem where my VE-LTFT and STFT tables won't show MAP values (y-axis) past 15 (all dump onto 1st line).

can you take a look at this and tell me whats wrong with my config?

you might notice that its running a little rich - still trying to figure out the best way to correct these 42lb injectors. a side question: should i simply adjust ifr a little more to get the fuel trims in line?

thanks!

[Bill@HPTuners]

Loads fine for me using the default imperial config file, it might be your regional settings(most likely) or a bad custom PID(less likely)

[BobDoLe]

regional settings - they're all at English (US) even in the advanced tab and everything.

here's a screenshot of the histogram.

i even tried using different configs and its still doing the same thing.

please advise what this could be

[Bill@HPTuners]

Probably one of your custom PID's then, try deleting the file named VCM Scanner.cfg from your hptuners settings folder to see if that fixes it.

[BobDoLe]

just tried that also - no change.
loaded default imperial.cfg - still same problem.

removed and re-installed hptuners suite - still same problem.

loaded up an old scan from way back when (when i know the map values were populating properly) - same problem.

so it must be my computer, right? any other suggestions on what regional settings to change/test?

THANKS!

[Bill@HPTuners]

Please post your VCM Scanner.cfg file so I can at least rule that out.

-Bill

[nick13618]

i had the same problem, it has something to do with the map sensor reading psi instead of kpa, it depends on what you have in the table.