The following tables seem to use engine torque % on the column axis:
- Power Enrich Lambda
- Desired Air Load
- Max Air Load Torque – This table uses engine torque % in the row axis, not the column axis.
- Max Torque
- Max Engine Torque vs. RPM vs. Gear
- Max Torque vs. RPM - This table uses engine torque % in the row axis, not the column axis.
The load in these tables doesn’t correlate to anything in the scanner that I can find.
Can someone from HPT comment on these types of load and their appropriate correlation in the scanner?
One point of confusion is both torque and air load are both labeled as '%' which I understand because that's what they are; however, a little more description in the label would distinguish between the two.
Thanks for the support.