Okay I searched and couldn't really find any help. I just hooked up my LC-1, analog 1 runs to interceptor gauge, analog 2 is wired to go into the EIO. Both outputs are setup as widebands. Does the LC-1 have to have a ground running to the EIO? I don't have one there because it is grounded with all the other grounds as Innovate suggests. I also don't have the hptuner module in the car all the time and needed it grounded to use the gauges. The interceptor reads fine. But I am not getting any data in the scanner from the wideband. Anyone had this problem or any suggestions as to what is wrong? I'm at my wits end