Speed Limiter in 2008 Escalade

[V8_Club]

Hi there,

I have been having a hard time trying to figure out how to remove the same. Any experience ?

Attached is the stcok file for reference.

[Bill@HPTuners]

Our stickies have a great whealth of information contained within

Turned off your speed limiter but it still cuts out at 100mph?

basically you need to set your speed limiters as you'd like & then set the source to calibration rather than GM LAN

[V8_Club]

Excellent. Thanks !!!!

[MC PERFORMANCE]

Our stickies have a great whealth of information contained within

Turned off your speed limiter but it still cuts out at 100mph?

basically you need to set your speed limiters as you'd like & then set the source to calibration rather than GM LAN

Hi Bill,
sorry for bumping an old thried. i just did that on a 2009 Escalade and once i uploaded the file. i got a Traction Message on the screen. any info on that

[Bill@HPTuners]

Hi Bill,
sorry for bumping an old thried. i just did that on a 2009 Escalade and once i uploaded the file. i got a Traction Message on the screen. any info on that

Any other changes made? Tire size or otherwise?

[MC PERFORMANCE]

just that nothing ells. i flashed the car back with the selection to GMLAN and the message disappeared.

[Bill@HPTuners]

Dunno, maybe the module doesn't like the new settings in the pcm, we see it alot with the abs module not liking tire size changes.

[Mep_q8]

It happens once in a while with a flash.. If you reflashed it with the same file once again, it should go away..

[midevil1]

Or just turn off the ignition for a few minutes and it goes away. Just needs a little time to reset.