Sorry if this is answered somewhere on here already, but I did a search and could not find an answer that worked. I can see the WB in my scan chart, but I get no reading when doing a scan. I can read the AFR on the LM-1 controller, but it will not display in HPT. I'm using the instructions in The Tuning School Quick Start Guide. It says I should have two red and one white wire, but that is wrong. I have one red, one white, and a copper. From what I have read so far, I believe the red and white wires are the output wires and the copper is the ground. I tried switching between the red and white wires but neither one gave me a reading. The third wire, (copper) is attached to pin #5 on the interface. I've attached my WB config file as well as a test scan. I used my 97 Grand Am for the test scan but I'll be using it to tune my T/A once I get it to work properly. Please help if you can.