LC1 PID only works specified as AEM WB.

[blackeco]

I have a LC1 and I have had it setup and working fine in the past. When I reloaded my system and HPT software, I was unable to get it to display anything after setting the PID to the LC!. Now if I set it to the AEM WB it displays results, but I don't know if they are correct.

Anyone have a clue what is going on here?

[5_Liter_Eater]

I'm not sure why that would be but if you look at the help file you can see the equations each of the built in WB PIDs use. That way you can verify if the AEM and LC1 are the same.

[blackeco]

thanks

[mcfarlnd]

set up your own by using soundengineers write-up. its a good one.