-
Tuner in Training
LM1 Help
I inhearted a LM1 from a friend of mine. Using the handheld module it works great, but I am not sure how I get it to work with hp tuners. I have read all of the LC1 info but it is not translating over to my LM1. Since the o2 gets it power and ground from the innovate module do I just need to tap into the signal wire and run it to my MPVI Pro?
Any help would be great.
-
Tuner
There should be a small jack with red, white, and bare copper wires. It plugs into the side of the LM1 box. The red and white are analog 1 and analog 2. (or is it analog 2 and analog 1...)
Anyway, you program the output of the analog wire in the LM1 to be the range you want, you setup a pid in hptuners to match, and feed the appropriate red or white wire into the EIO slot. (or onto the egr or ac pressure feed, if you go that route.)
-
Tuner
Any idea what the range of the built-in PID for the LM1 is for?
If my math is correct, it's 10:1 to 20:1. I hope that's right.
Last edited by LinearX; 04-16-2008 at 10:01 PM.
-
Tuner in Training
Thank you, I was missing the analog out cable. I ordered it from innovate and it is now working.