I have my LC-1 wideband wired into the VCM using the EGR input. I have enabled the EGR in the editor and set the Enable/Disable speeds to 0 mph. I have tried my best to get the scanner to read the EGR input, but can't get it to work. I have created a custom PID with the following details:
Name: AFR - Phil
Abbrv: AFR
Sensor: Air Fuel Ratio
Units: afr
Function:[PID.2811]*3.008+7.35
When I add the PID to the chart, nothing comes up. When I add it to the table it says 'unsupported parameter' after I start logging. Could anyone walk me through how to make this work. I'm about to bust over here... I appreciate your help.