how to check cylinder misfires

[12leavu]

i have the standard 499.00 kit. i just recieved it today and have been pulling my hair out trying to figure it out. the main reason i bought this was for diagnostic purposes. im trying to read individual cylinder misfires but after all day of searching i have had no luck. i did find where you load the pids into the table display but from what i see i need the other interface to do so. is there a way that i can configure this to work. if so can someone explain it to me clearly? i am having misfire problems under load at part throttle. i need to see what cylinders are misfiring. thanks

[Bill@HPTuners]

Turn on your laptop
Click Start-All Programs-HP Tuners-VCM Scanner
Connect your interface to your laptop
Connect your interface to your vehicles obd2 port
Start the vehicle
Click File-Connect in the vcm scanner
Open your table(primary) display
Right click on an empty cell and click insert, the insert pid list will open
Open Engine Diag-Misfire and choose the pid's you want to add.
Close the insert pid list
Then click the start scanning button.

[12leavu]

thanks. i was running the scanner while i was trying to add pids.