When setting up AFR in my PID, I noticed there was 3 listings. AFR ratio error,AFR command Hi res., and AFR command Lo res. Which if any of these 3 should I insert in my PID file in order to log AFR.
When setting up AFR in my PID, I noticed there was 3 listings. AFR ratio error,AFR command Hi res., and AFR command Lo res. Which if any of these 3 should I insert in my PID file in order to log AFR.
AFR Error is different than AFR Commanded and none of these will tell you your actual AFR. You need to insert the EIO PID for your wide band to tell your AFR. Then you will need to log commanded AFR (either low or high res) to be able to have the AFR Error PID calculate the error. Go with low res.
Bill Winters
Former owner/builder/tuner of the FarmVette
Out of the LSx tuning game
I do not understand! Where do I find this (EIO) pid for my LM1
Do you have the Pro version?
Bill Winters
Former owner/builder/tuner of the FarmVette
Out of the LSx tuning game
YesOriginally Posted by 5_Liter_Eater
In your table right click in the EIO section and add your Wideband there.
Mitchell
'04 Supercharged MC SS
MOD LIST
Custom PCM, Ram Air Hood w/ Air box, Intense MPS w/3.6", R/T DP with Ubend delete & HF CAT, LC-1 WB, GMPP Cat Back, Jacobs wires, 180 T-stat, & an Optima Red Top