Hi all,
still doing a lot of reading and learning!!!
I got the Innovate Wide Band and I remember reading someplace where a guy set his sensor on short piece of 1 1/2- 1 5/8 exaust pipe with a clamp so he move it from vehicle to vehicle easily.
I also read that on a car with cats the reading is going to show leaner then it would be before the cats.

Does anyone use a set up like this?

How much leaner would the reading be with cats?

Innovate warns about moisture being bad and I see moisture often dripping from cars specially during warm up.

I realize the sensor should be mounted on the top side of the pipe.

Any thoughts on this?

Thanks in advance

Carlos