Results 1 to 2 of 2

Thread: LC-1 set to replace NB o2 output hangs at 447

  1. 06-08-2007 #1
    BloatedCow
    BloatedCow is offline
    Potential Tuner
    Join Date
    Jun 2007
    Location
    Phoenix, AZ
    Posts
    9

    LC-1 set to replace NB o2 output hangs at 447

    Howdy I am running my LC-1 as a NB o2 as well as a wideband but it is only puting out a constant reading of 447, the wide band outout seems to work. Does the lo ground on the 4 pin o2 harness need to be grounded to a common ground on the EIO? Any help would be great thanks. Right now I just have 2 wires on the o2 wiring harness the 12v power and the signal in. Any ideas would be great, I changed the speed the output through the LC-1 programer to 1/6 but this had no effect on the NB output.
    Reply With Quote Reply With Quote
  2. 06-08-2007 #2
    BloatedCow
    BloatedCow is offline
    Potential Tuner
    Join Date
    Jun 2007
    Location
    Phoenix, AZ
    Posts
    9
    Nevermind it looks like I do need to ground out the o2 harness at the EIO
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »