Hello again
I followed the HPT help instructions to set up new PID to display MAP in PSI. I chose the [SENS.30.IMP]-14.5 function and then logged a robust run afterwards. When analysing the log the new PID reading never moved out of a negative range which is clearly incorrect. My boost controller revealed I peaked @ 12psi. Also, the standard MAP 2bar KPa PID on the table indicated a max of 26.5psi (I assume take 14.5 from this which leaves 12psi - ie consistent with the boost controller reading).
Hence I am unsure why the newly created PID is not working. I thought I would check the function (to see if I made a transposition error) but cant seem to access it. I might try the other version and see how it goes. Any suggestions will be appreciated.
thanks