I was doing some experimenting and changed some of the prediction coefficients and now I would like to to change them back to stock (as seen in the screenshot), however, the OEM calibration exceeds HPT's range of +/-1000. Is this a defect on the HPT side? I am scared to click yes to the warning message.
mismatched data range.jpg
scary warn.jpg
A standard approach will give you standard results.
My Tuning Software:
VVE Assistant [update for v1.5]
MAF Assistant
EOIT Assistant
I have to admit I would follow the instructions and contact support.
Yeah, they're bugs. Wind them out. Min: -3.4E+38 Max: 3.4E+38
CTRL+L, find one from before you made the change, right-click & Open in New Editor and save.
This happens in other tables as well, depending on year/platform.
screenshot.24-04-2024 21.00.19.png
yep, that one always confused me.Originally Posted by blindsquirrel
Also some gen 3's will have 12xx in some max torque tables from the factory when the editor only allows 640.
Tuner at PCMofnc.com
Email tuning!!!, Mail order, Dyno tuning, Performance Parts, Electric Fan Kits, 4l80e swap harnesses, 6l80 -> 4l80e conversion harnesses, Installs
At least I think I understand the reasoning behind exceeding the max on that one, it changes the shape leading up to/after the peak and the dwell time at 194F, even if the value the ECM uses never goes over 2.000.
screenshot.25-04-2024 17.49.20.png
Reply With Quote