My Scanner is reading 0 on my exhaust cam angle. I thought maybe something was up with my sensor or the PCM. I went back to an old log where it read 125 and that old log is now showing 0.
Any ideas on how to address this?
My Scanner is reading 0 on my exhaust cam angle. I thought maybe something was up with my sensor or the PCM. I went back to an old log where it read 125 and that old log is now showing 0.
Any ideas on how to address this?
No, nothing is wrongOriginally Posted by McCloud
What version of vcm suite were you using when you created that older log? What version are you using now?
Yes, I can help you. iirc yours is a 2011, correct??? JPEC??
Version is 5.0.4 same version with old log.
yes 2011 GPEC2
with a JPEC2 controller the parameter to log is 'exhaust cam center position'
with the JPEC2a look for 'exhaust cam angle'
Reply With Quote