T43 - TCC Adapts - Strange Behaviour

[PHLTHS]

Hi All,

For some strange reason, once I enabled TCC adapts on my 6L50 / T43 controller, at steady state driving, Speed, Torque, TPS all steady, I see the TCC pressure just constantly increasing.

Any idea whats going on here? I was under the impression that the TCC Adapts are meant to lower the TCC pressure until it detects slip above what is set in the slip tables (in this case 0) and then increase just a little to hold that slip rate.

I've attached my log, my tune and also a screenshot where you can see the TCC Desired Pressure just keeps increasing.

TCC Pressure Ramping Up.png

AUTO-PWRPHL_0180.hpt

TCC Tune 180 - Shifts & Lockups Nice, TCC Adapts Enabled.hpl