Recently installed a LS3 into my C5 corvette. This is the first vehicle I have tuned and I am having a difficult time getting it to idle to really begin tuning. I have adjusted the ETC scalar for the throttle body, flow rate for the injectors and cylinder volume for the different engine. I have been able to get it to start and have logged what information I could during that time. I am using a lingenfelter 58x-24x module(trg-002). I tried to go through and set as much as I could to match a camaro with as LS3 hoping to get a starting point.
Mods:
LS3
38 lb injectors
LS2 throttle body
LS3 intake
Camshaft (243/253 620/629 113 LSA)
Holley fuel rails
I think that is all that would require adjustments. This is my most recent tune and data log that goes with it. The tune labeled LS2 scalar only has some DTCs turned off, injector flow and ETC scalar changes.
HELP!!