Originally Posted by
fixbroke
Interesting. I assume you must have looked at my log and tune to figure that out, and I'm grateful for your taking the time to do so.
I'm curious how I might have screwed up my MAF tune. I mostly followed the MAF tuning guide on Youtube from Goat Rope Garage, which didn't involve touching any PE settings. From his guide, I disabled DFCO, open loop, LTFT, COT, CFCO, and dynamic airflow. However, I also followed HP Academy's MAF tuning video which suggested setting the entire gas PE table to a fixed value (I went with 1.195).
I switched all of those back to the factory settings when I was done with MAF and SD tuning. My final MAF tune showed an EQ error within 2-3% across the range, mostly on the rich side. EQ error in subsequent logs looked good.
Should I have done something different while MAF tuning? Should I have disabled PE entirely?