So I have my wideband sensor setup and was able to configure it in HPTuners to have realtime readouts. The problem is I think its reading at 1/2 of what it should be. Could the formulas I'm using be wrong?
Here's what I currently have set for them both:
AFR (input/68.05) + 7.36 = output
EQ Ratio (Lambda: (input/1024) + 0.5 = output
Anyone have something else you're using currently?
Last edited by derickab72; 12-25-2023 at 06:27 PM.
So I played with the math a little bit. What I did was record logs at idle with logworks ( the software that Innovative uses) and tried to get the logging in HPTuners to match it. Once I was able to get them to match did some pulls. One pull with logworks and one with hptuners. Watched both logs simultaneously and they were dead on. I just played with the math in HP Tuners until they matched up. The screenshot is the math I used to get it working.
Reply With Quote