AFR wideband route?

[lynnRoo]

going to be installing one on my 2016 ram 1500 W/ 6.4 stock cam, non mds

im obviously going to be checking out any good install videos i can find, and making sure its an air tight weld..BUT...

There anyone with similar year construction that have any tips on the best route to run it?
Any thing i should avoid other than obvious heat sources?
or are there any extra measures or products i should use to keep it safely wired, or that may help prolong the longevity of the wires/sensor itself?

[f.creek-ranch]

I do not understand your question.
Place it , wire it, finish. That’s it.
It not a question for tuning, not for software…
Maybe Obd hardware and communication.

Set the WB on the top of the tube to avoid condensate.

[lynnRoo]

will place the thread in right place. sry bout that.
ive just never ran any type of sensor wiring. ive done speaker system at most.