File is tuner locked again. Did you get new injectors?
File is tuner locked again. Did you get new injectors?
Nope loaded the tune you said to try and black smoke went away but went pig Ritch. And no idea why it's locked I haven't changed anything
Sorry that's me being an idiot. I clicked the wrong file. Anyway...here's a baseline VE.
ok thank you i still was looking and was like why is it locked lock and i have other logs as well if needed
Sure let's see how it's doing.
11-23=23.hplbobbys stock file 2bar11-19-23_SiriusC1024_Injectors_NonReferenced_VE.hpt
seemed alot better to me but looked like fuel trims went from -21 to positive 40s and 50s at idle then when gave it gas would come rich also noticed that the difference from bank one and 2 was alot. thanks again for all the help and seems to be close to drive time for it
Given the corrections, VE was coming in pretty low. So, I changed the density for the cc/min conversion to that of n-heptane. n-Heptane is typically used for flow ratings. Still, it's kind of low.
Set up a few more parameters in the tune.
I see STFT's are still active even though CL is disabled. Don't know for sure if they are affecting things. Use VCM Scanner to clear them.
Log this one.
ok thanks and i am loging only stft as speed density only no maf and no 02 sensors, except wideband. also it has a stage 2 turbo cam but isnt coming through almost sound stock really which i am confused about its a brian tooley stage 2 i didnt know if all the stock info was taking over the tables as when i add the info to the ve it shoots it way down and to 0s etc and isnt a slope like table that is loaded, and again i thank you for all the input and help is their channels and etc i need to log and i can donate for you helping if need be
It should sound different as fueling gets more accurate. Are both front O2's still in place?
yes if i remember right only the rear 02s are not in i belive the 2 front are in and then the wideband is in
If front O2's are still in there then we'll use them. CL re-enabled in this tune. On the next log include the channels LTFT and STFT for bank 1 and bank 2, please.
Screenshot (8).png i just noticed alot of differences in the data from chart vs time to channels added a pic also if i do the math on injector duty cycle it does not match from scanner to math
rpm by ipw 4330 showing on scanner and ipw of 4.3 and 4.4 should be 15.5 percent duty cycle but in the scanner it says they are only at 4.9 percent
I'm not sure what's going on with that pic. You're right it should be showing 15% DC. When I open the log at post #27, scanner shows 11.2% DC @ 2960rpm.
Post another log with the latest tune.
No I don't. What's the problem though? Injectors weren't changed between the two logs where DC worked then didn't. Wouldn't you like to see how far off these injectors are before deciding to buy new?