Hello all,
I have been tuning on my VE tables and it looks steep on what I am calling the low side.
2005 5.3, LM7, truck Norris cam, flex fuel injectors
Thanks in advance.
Hello all,
I have been tuning on my VE tables and it looks steep on what I am calling the low side.
2005 5.3, LM7, truck Norris cam, flex fuel injectors
Thanks in advance.
What flex fuel injector flows 30.44lbs?
https://www.injectorplanet.com/produ...otors-12580426
this www shows 29.9lb hr at 43.5 psi /3 Bar , not sure what the 3 bar is al about
I am at 45 psi
Corvette filter / regulator
Must be a pretty weak pump to only flow 45psi. You wouldn't need the filter/regulator if you are able to keep a high power pump down to 45psi, you'd have a regulator just for that.
Past that, the VE looks just fine to me. Honestly looks like a stock table without comparing them.
2016 Silverado CCSB 5.3/6L80e, not as slow but still heavy.
If you don't post your tune and logs when you have questions you aren't helping yourself.
3 bar is what they are rated at. Corvette reg is 4 bar. Despite this, 3 bar rating goes into Flow Rate vs KPa.
100% in cranking VE is incorrect.
Rechecked my fuel pressure and it is 58psi.
So I need to adjust for that and start over.
12580426 is the L59 VIN 'Z' injector. Copy in Flow Rate vs KPA, Min Injector Pulse, Offset vs Volts vs VAC, & Short Pulse Adder tables from a 2005-up (returnless @58PSI, same as yours) VIN 'Z' truck.
whatisinjectordata.png
2006 Avalanche 3GNEK12Z46G198319 L59 12580426 35lb 58psi nonref.hpt
Eh if it's like stock then nvm. I'm used to seeing f-body/vette VE plots. Follow the squirrel's advice.
At zero RPM volumetric efficiency is 100%, can't be anything less than that. Cranking speeds are generally low enough that even tiny throttle openings/IAC positions are enough air to fill the cylinders, so not much vacuum is created. Hell, most every (maybe actually every) Gen 4's cranking VE table is all 100's. Unless you have a mega-starter and a massive bank of supercapacitors and it cranks at 400 RPM or something, I don't think that table matters that much.
Makes sense.
Tuner at PCMofnc.com
Email tuning!!!, Mail order, Dyno tuning, Performance Parts, Electric Fan Kits, 4l80e swap harnesses, 6l80 -> 4l80e conversion harnesses, Installs
I believe I have the injectors figured out, Trying to do something about my idle , IAC don't seam to be responding, idles around 800 IAC reads 309 and special functions don't do anything with the idle speed, need to make a new thread.
Thanks to all